Preferences
General tab:
- Intervals: Write to database each (%number%) seconds: Default 5 sec., which mean that, if write to database for Input - Output components is enabled, data received from Arduino device will be stored in database each 5 seconds, only if previous state is changed.
- NOK status interval (%number%) seconds: Default 30 sec, which mean that if data from Arduino device is not received 30 seconds either from serial or network, row in list view with this Arduino device will show NOK status, all Input - Output components became grey. As long as data are received either from serial or network, status will be OK and components colours are green or red depending of Arduino I/O status.
- Log Properties:
- Show CRC errors: If checked, in log window will be showed CRC errors, only for debugging
- (%number%) max. lines in log: Default 2000, maximum allowed lines in log window placed below components layout.
- Serial port handling:
- Open all devices serial ports at startup: Opens up all Arduino devices serial connections, connected with USB cable to the computer. If port does not exists or not available, error will be showed in log window bellow pin list.
- Altitude at your location: Parameter used for altitude sensor like BME280, supported in ACC.
- Send ping before sending data over network: ACC send ping request to Arduino device before sending data, UDP server has to be up and running.
Mail setup tab:
- Read more here
SMS setup tab:
- Read more here
Notifications tab: Arduino status notifications (data stopped receiving from Arduino device, serial and network)
- Send notification on NOK status after (%number%) minutes: Default 30 minutes. This mean, that if receiving data from Arduino stops, after 30 minutes notifications will be sent over E-mail, SMS or sound alarm will activate (windows).
SMS and E-mail has to be configured and activated for notifications, each Arduino device also has to be enabled for notifications(Edit -> Device Properties) either for e-mail, SMS, sound or all , with added e-mail addresses and mobile numbers.
- and stop after (%number%) retries: Default 1 time. Number of resend e-mail notifications, SMS will always be one message for NOK and OK status.
- Send notification on OK status back. OK status should be at least (%number%) minutes: Default 30 minutes. After 30 minutes regularly receiving data from Arduino device, OK status notification will be sent over E-mail and SMS, sound alarm will stopped immediately on OK status (windows, can be turned off manually).
SMS and E-mail has to be configured and activated for notifications, each Arduino device also has to be enabled for notifications(Edit -> Device Properties) either for e-mail, SMS, sound or all, with added e-mail addresses and mobile numbers.
- Play sound on NOK status: Sound notifications in Windows. General setup for all other sound notifications for Arduino device or components.
NOTE: These are general notification settings. Each device notification has to be enabled separately - Device Properties->Enable device notifications(OK - NOK status)